DA-682A-DPP Hardware
Hardware Installation
2-15
Step 9:
Connect the cables to the appropriate jacks (power to the top one and data below).
Single Disk
Dual Disks
Installing and Removing Expansion Modules
The DA-682A-DPP embedded computer has two slots for DA expansion modules. There is no designated
primary or secondary slot; modules may be installed in either slot A or slot B. To install or remove expansion
modules, follow these instructions:
1.
Disconnect the DA-682A-DPP from the
power source.
2.
Unfasten the screws locking the covers
of the expansion module A or module B
on the rear panel.
3.
Insert or remove the expansion module by carefully
pushing or pulling, in unison, on the two thumbscrews.
Be certain to apply pressure evenly across both screws,
to ensure that the board is not damaged.
Apply pressure firmly but evenly here
Thumbscrews
Thumbscrews
