AirWorks AWK-4121 User’s Manual
Introduction
ATTENTION
When the LEDs for
STATE
(Green),
FAULT
, and
WLAN
all light up simultaneously and blink at
one-second intervals, it means the system failed to boot. This may be due to improper operation or
uncontrollable issues, such as an unexpected shutdown during firmware update. To recover the
firmware, refer to “Firmware Recovery” in Chapter 6.
Beeper
The beeper signals that the system is ready with two short beeps.
Reset Button
The
RESET
button is located on the bottom panel of the AWK-4121. You can reboot the
AWK-4121 or reset it to factory default settings by pressing the
RESET
button with a pointed
object such as an unfolded paper clip.
y
System reboot:
Hold the RESET button down for
under
5 seconds and then release.
y
Reset to factory default:
Hold the RESET button down for
over
5 seconds until the
STATE
LED starts blinking green. Release the button to reset the AWK-4121.
STEP 1: Remove the reset button cover.
STEP 2: Using a pointed object, press and
hold the reset button.
1-6
