Movex ASEM 125, Manual

Page: 8 / 16

8 Manual
FUMEX ASEM 65/85/125
2
3
4
5
1
Manual
MOVEX ASEM 65/85/125
Wall and floor mounting
5. Remove stop clip for roll-out (1, Fig. 7 ).
6. Install the hose (2, Fig. 10 ) with any reducer (1) on
the hose reel connection with hose clamps (3).
Fig. 9
Fig. 10
The hose must be secured.
To secure the hose, use AESM 100/125/150;
see chapter
11 Accessories .
7. Secure the hose using a rubber cloth and hose
clamps according to
Fig. 11 .
8. Coarse adjustment of end position for retraction:
Rotate the drum and roll in the entire length of the
hose, or as much as fits on the width of the hose
reel.
9. Remove stop clip for retraction (6, Fig. 7 ).
10. Release motor disconnect switch and refit the
cover.
11. The hose reel is now ready for mounting and
installation.
4.3.6 Mounting the hose reel
Fasteners used to mount the hose reel on
the ceiling or wall must be dimensioned for
the purpose.
The machine must be lifted into place using
an approved platform (e.g. scissor lift). The
platform must remain in place until the pro-
duct is fully attached.
At least two people are required to mount
the machine.
1. Check the reel and ventilation ducts properly to en-
sure that foreign objects are not present. Remove
any such objects immediately.
2. Mount the machine on the ceiling or wall.
If the exhaust duct does not align with the
mounted machine’s duct connection, acces-
sory ASL-160 can be used as a bridge.
3. Connect the exhaust duct to the machine’s duct
connection.
Fig. 11