2
Required Building Supplies
!
X-acto
TM
with #11 blades
!
Thick and thin CA – Cyanoacrylate glue (Super Glue)
!
Sanding block with 200 grit sandpaper
!
Smooth, flat work table
!
Wax paper to protect plans
!
Needle nose pliers
!
Wire cutters
!
Hobby Iron for applying covering – also called a sealing iron
Required Equipment
!
Four channel radio minimum, 5 channel preferred for aileron/ flap mixing
!
Four micro servos: Hitec HS55s recommended
!
GWS EPS300C-D motor with 12x6 propeller
!
Electronic Speed Control (ESC) capable of handling at least 10 amps
!
Battery pack: 8 cell 600mAH Nicads or 720mAH NiMH configured 4 over 4
Parts List
Loose Parts
1 ea – 1/16” laser cut plywood sheet
3 ea – 1/32” laser cut balsa sheets
5 ea – 1/16” laser cut balsa sheets
2 ea – 3/32” laser cut balsa sheets
1 ea – 1/8” laser cut balsa sheets
1 ea – 1/64” plywood wing servo mounts
2 ea – cowl balsa
2 ea – 1/4" square x 18” balsa leading edge
3 ea – 1/32” x 18” thin music wire for tailwheel and pushrods
1 ea – Plastic Canopy
1 ea - Covering
Bagged Parts
1 ea – Motor Mount 1/16” ply sheet
2 ea – 3/32” x 7.5” landing gear wire
1 ea – 1/8"round x 2.75” hard wood dowel
1 ea – 6” x 3/32” heat shrink tubing for pushrods
1 ea – 1/2" x 1/8” heat shrink tubing for wheel retainers
1 ea – 6” Velcro strip for mounting the battery and receiver
2 ea – Wheels
1 ea – 4” tailwheel tire rubber
1 ea - Neodymium canopy hold down magnet with tack
1 ea – Tyvek strip for canopy hinge and tailwheel reinforcement
1 ea – 4-40 wing bolt
F1
F2
F3
F4
F5
F6
F7
F8
F9 F10
