12
CORRECT INSTALLATION FOR THE TWIN/DOUBLE ABC
RECLINING/NEWBORN TODDLER SEAT ONTO THE ABC TWIN
ADVENTURE BUGGY
CAUTION: MAXIMUM WEIGHT CAPACITY;
RECLINING TODDLER SEATS Total 25kg
CAUTION:
The Reclining Newborn/Toddler Seat (R-T/S)
adaptor bar is required to rest against the top of the buggy
frame for correct balance and stability. The R-T/S must be
positioned directly over the buggies rear wheels.
REMOVE THE HANDLE BAR FROM THE BUGGY
1) Unclip the top press studs on the canopy and top of buggy sling / seat.
2) First apply the brake. Then loosen the tri-knobs at the base of the handle bar, pull
the handle out to the end and two springs will spring into position. Depress the spring
buttons on the side of the frame one at a time and also pulling the handle each side as
you go.
3) Remove the handle bar from the buggy frame.
INSTALLING THE ADAPTOR BAR ONTO THE EXTENDIBLE HANDLE
1) With the Adaptor bar prongs for toddler seat facing you, enter the extendible
handle bar into the tube brackets of the Adaptor Bar.
2) Slide the handle through the Adaptor bar tube openings (note: you will have to
depress the safety buttons on the handle to complete the process).
RETURN THE HANDLE/ADAPTOR BAR ONTO THE BUGGY
1) Ensure your sun canopy is out stretched into the sun protection position.
2) Slide the Adaptor bar half way up the handle.
3) With the Adaptor Bar now installed on to the extendible handle, return the
handle/Adaptor Bar combination to the buggy.
4) Ensure the safety buttons have clicked into the safety holes of the buggy frame
(which is the fully extended position of the handle).
5) Attach the R-T/S to the Adaptor Bar, depressing the spring lock buttons on the
Adaptor Bar to allow the R-T/S to sit at the base of the adaptor bar prongs.
6)
IMPORTANT
:
Slide the Adaptor Bar down the handle so that the Adaptor bars
tube brackets are flush with the
TOP
of the buggy frame.
NOTE: The Adaptor Bar is required to rest against the top of the buggy frame
for correct balance and stability. The R-T/S must be positioned directly over the
buggies rear wheels.
7) Tighten the tri-knob screws under the handle bar to secure the handle into place.
