![background image](http://html.mh-extra.com/html/moulinex/compact-chef/compact-chef_manual_1839765038.webp)
31
EN
PROBLEMS
CAUSES
SOLUTIONS
Leak through the motor-unit lid.
Too many ingredients have been added.
Reduce the quantity of ingredients
added.
The sealing ring is not present.
Position the sealing ring on the
seal-mounting cup and clip to the
motor-unit lid.
The sealing ring has been cut or is
damaged.
Replace the sealing ring - contact an
authorised service centre.
A problem with the accessories.
Check that you are using the
recommended accessory.
Smell from the motor.
When first using the appliance, or in
the event of motor overload caused by
adding too many ingredients, or pieces
that are too large.
Leave the motor too cool (for about 30
minutes) and reduce the quantity of
ingredients in the jug.
"
1
SECU" appears on the display.
A motor overload caused by adding
too many ingredients or pieces that
are too hard or large, or a processing
succession of recipes without sufficient
cooling time.
Allow the motor to cool down
(approximately 30 minutes) and
reduce the quantity of ingredients
in the jug, check that you are using
the right programme, as well as the
recommended accessory and that you
are not exceeding the capacity of the
appliance.
"
2
SECU" appears on the display and a
red indicator light flashes.
The temperature sensor is overheating
due to the jug being too hot because it
is empty or has too few ingredients.
Add ingredients to the jug.
"
3
SECU" is displayed and a red indicator
light flashes.
The heating resistor does not work.
Check that the pins in the connector
under the jug are not dirty. If this is
the case, clean them and try again.
If this still does not work, contact an
authorised service centre.
"Err1" is displayed.
The temperature sensor no longer
works.
Contact an authorised service centre.
"Err2" is displayed.
Electronic fault.
Contact an authorised service centre.
The safety lock indicator appears
(C3)
on the LDC display.
The jug or motor-unit lid has not
locked into place properly.
Check that the jug is correctly
positioned on the base and that the
motor-unit lid is correctly locked in
place (the padlock will no longer
appear on the screen).
Motor overload.
Allow the motor to cool down
(approximately 30 minutes) and
reduce the quantity of ingredients
in the jug, check that you are using
the right programme, as well as the
recommended accessory.
You are sure that everything is
assembled correctly but the problem
persists (the padlock can be seen on
the display), in this case, contact an
approved service centre.
Summary of Contents for COMPACT CHEF
