MOULDPRO TCU-200, User Manualline

Page: 13 / 42

[13]
User Guidelines
– TCU-200
12-06-2019 Vers. 003
5 Installation
Before starting the unit, the electrical and hydraulic connections have to be installed. The installation of the
unit has to be done in the order of the following chapters. After the proper installation, the unit is ready to use.
DANGER
The temperature control unit must only be operated with water. Do not use
solvents or other explosive substances such as petrol, toluene, etc. in the
water.
CAUTION
When starting the unit without the prescribed connections the unit can be
damaged.
Water quality
– do not use water with chlorine addition.
NOTE
Observe the General Safety Information!
Before installing corresponding chapter of the manual should be read!
5.1 Installing and dimensions of the temperature control unit
The temperature control unit is designed for an ambient temperature of +10 up to 40°C. Sufficient ventilation
must be ensured during set-up. The distance between the temperature control unit and other facilities must
be at least 10cm. The ventilation opening must be free.

Check the unit of completeness and possible damages.

The unit has to be installed in a suitable location on even ground. It must be stand up right on the
wheels (castors).

The unit is not protected against splash water and is not suitable for use in hazardous location. The
unit must not be used in the open air.

The unit must not be transported lying down, transport in any other position than up right, will damage
the unit.