Motorola Solutions RFS7000GR Series RF Switch Secure Installation Guide
2
1.3 Warnings
•
Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the system to its power source.
•
Remove jewelry and watches before installing this equipment.
•
Install the equipment in a rack with adequate dimensions and weight allowances.
•
Verify the rack is anchored and cannot tip over or break away from its mountings.
•
Verify the unit is grounded before connecting it to the power source.
•
Verify any device connected to this unit is properly wired and grounded.
•
Connect all power cords to a properly wired and grounded electrical circuit.
•
Verify the electrical circuits have appropriate overload protection.
•
Attach only approved power cords to the device.
•
Motorola Solutions strongly recommends the use of an Uninterruptible Power Supply (UPS) that
supports the RFS7000 Series RF Switch power rating. Not using a UPS can result in data loss or
equipment damage due to a power surge or power failure.
•
Verify that the power connector and socket are accessible at all times during the operation of
the equipment.
•
Do not work with power circuits in dimly lit spaces.
•
Do not install this equipment or work with its power circuits during thunderstorms or other
weather conditions that could cause a power surge.
•
Verify there is adequate ventilation around the device, and ambient temperatures meet
equipment operation specifications.
1.4 Site Preparation
•
Consult your site survey and network analysis reports to determine specific equipment
placement, port capacity, power drops, and so on.
•
Assign installation responsibility to the appropriate personnel.
•
Identify where all installed components are located.
•
Verify appropriate rack mounting requirements.
•
Provide a sufficient number of power drops for your equipment.
•
Ensure adequate, dust-free ventilation to all installed equipment.
•
Identify and prepare Ethernet and console port connections.
•
Verify that cable lengths are within the maximum allowable distances for optimal signal
transmission.
WARNING!
Indicates a condition or procedure that could result in personal injury or
equipment damage.
