Motorola PL3307, Integration Manual

Page: 163 / 336

Serial Interface 8 - 3
Serial Host Parameters
Various serial hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron, or Common Use Terminal Equipment
(CUTE-LP/LG bar code readers) sets the defaults listed in
Table 8-2 .
Table 8-2
Terminal Specific RS-232
Parameter ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-Nixdorf
Mode B/
OPOS/JPOS
Olivetti Omron CUTE
Baud Rate 9600 9600 9600 9600 9600 9600 9600
Parity Even None Odd Odd Even None Even
Stop Bits One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit 7-Bit
Hardware
Handshaking RTS/CTS
Option 3 None RTS/CTS
Option 3 RTS/CTS
Option 3 None None None
Software
Handshaking None None None None ACK/NAK None None
Serial Response
Time-out 9.9 Sec. 2 Sec. None None 9.9 Sec. 9.9 Sec. 9.9
Sec.
RTS Line State High Low Low Low = No data to
send Low High High
Beep On <BEL> Disable Disable Disable Disable Disable Disable Disable
Transmit Code ID Yes Yes Yes Yes Yes Yes Yes
Data Transmission
Format Data/Suffix Data/Suffix Data/Suffix Data/Suffix Prefix/Data/
Suffix Data/
Suffix Prefix/
Data/
Suffix
Prefix None None None None STX (1002) None STX
(1002)
Suffix CR (1013) CR (1013) CR (1013) CR (1013) ETX (1003) CR (1013) CR
(1013)
ETX
(1003)
In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
If you scan Nixdorf Mode B without connecting the decoder to the proper host, it may appear
unable to scan. If this happens, scan a different serial host type within 5 seconds of cycling power
to the decoder.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select
CUTE, scan
*Enable Parameter Scanning (01h) on page 4-6 , then change the host selection.