Safety Precautions
These precautions help protect you and your MG7700.
Do not put the MG7700 or its power cube in water, since this is a shock hazard.
The MG7700 should normally be installed indoors. If you use it outdoors, protect it from moisture and be
careful about temperature.
Your MG7700 should be operated in an environment that’s between 32 and 104° Fahrenheit (0 to 40°
Centigrade).
Your MG7700 should not be in a confined space. There should be room for air flow around the top, front,
and sides of the MG7700.
Make sure to use your MG7700’s power cube and a compatible electrical outlet.
The coaxial cable's ground shield is intended to be connected to the building's Earth ground. Attachment
to Earth ground is typically provided through your cable service provider's installation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: reorient or relocate the receiving antenna, increase the separation
between the equipment and receiver, connect the equipment into an outlet on a circuit different from that to
which the receiver is connected, and/or consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and it
also complies with Part 15 of the FCC RF Rules. This equipment must be installed and operated in
accordance with provided instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna
installation instructions and consider removing the no-collocation statement.
This device complies with Class B Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
DC input connector is center-pin positive polarity.
MTRLC LLC PO Box 121147 Boston, MA 02112-1147
©MTRLC 2018. MOTOROLA and the Stylized M Logo are trademarks or registered trademarks of
Motorola Trademark Holdings, LLC. and are used under license. All other trademarks are the property of
their respective owners. All rights reserved.
27783-EL-A
/0237
