Motorola M80NCA6TZ5AN, Installation Manual

Page: 31 / 92

INSTALLATION MTM800 Enhanced Mobile Terminal Installation Manual 31
Ignition Sense Cable Installation
The HKN9327 Ignition Sense Cable allows the terminal to be turned on and off by the vehicle
ignition switch.
The ignition sense cable kit contains a thin cable and a fuse holder. To install the cable, carry out the
following steps.
1. Plug the lead of the Ignition Sense Cable with the crimped on terminal into #10 socket of the
accessory plug.
2. Route and secure the cable with attached tie wrap.
3. Connect the other lead of the accessory cable to the ignition switch of the vehicle.
4. Insert the fuse into the fuse holder and close the cover.
Figure 3 Accessory Connector with Ignition Sense Cable
Table 2 Ignition Sense Cable
Number Description Rating
HKN9327 Ignition Sense Cable with fuse 4 A Ignition Sense Cable, Length: 3 m
6580283E02 Fuse 4 A for Ignition Sense Cable
In cases of blown fuses, replace ONLY with those of
identical value.
NEVER insert ones of different values.
Ensure that the fuse is removed during cable installation.
If the ignition line is not used, it needs to be grounded.
Interference can cause radio to hang.
15
16
1
2
10