Motorola LEX L10, Manual, Page: 129 / 158

6 For open networks, tap profile once or press and hold and then select Connect to network or for secure networks
enter the required password or other credentials then tap Connect . See technical support for more information.
The LEX L10 obtains a network address and other required information from the network using the dynamic host
configuration protocol (DHCP) protocol.
7 In the WiFi setting field, Connected displays indicating that the LEX L10 is connected to the WLAN.
8.2.2 Configuring a WiFi Network
Procedure:
1
Tap .
2
Tap .
3
Tap WiFi .
4 Slide the switch to the ON position.
The LEX L10 searches for WLANs in the area and lists them on the screen.
5 Scroll through the list and select the desired WLAN network.
6 Tap the desired network.
If the network security is
Open , the LEX L10 automatically connects to the network. For all other network
security a dialog box appears.
Figure 95: WLAN Network Security Dialog Boxes
Note: By default, the network Proxy is set to None and the IP settings is set to DHCP .
7 If the network security is WEP or WPA/WPA2 PSK , enter the required password and then tap Connect .
8 If the network security is 802.1x EAP , enter the information below and then tap Connect :
• Tap the EAP method drop-down list and select PEAP , TLS or TTLS .
• Tap the Phase 2 authentication drop-down list and select an authentication method.
• If required, tap CA certificate and select a Certification Authority (CA) certificate. Note: Certificates are
installed using the Security settings.
• If required, tap User certificate and select a user certificate. Note: User certificates are installed using the
Location & security settings.
Wireless | 129
MN001456A01-A | February 2015 | Send Feedback