Motorola DH6200, Installation Manual

Page: 38 / 72

4 DIAGNOSTICS
28
3. When the desired new frequency has been selected the operator will press the
SELECT key to start the search. The manual frequency search will last up to 40
seconds. As the set-top searches, the frequency being searched for will flash on the
Front Panel. On the OSD the “MAN FREQ” line of text will be cleared, the “HUNT
MODE” will display “FIX” to indicate a search on a fixed frequency, and the “OOB
FREQ” field will change to the frequency being searched for.
4. If the frequency is found with the proper EMM Provider ID then the Front Panel will
display the normal OOB receiver status. The OSD “LKC” field will change to display
the new frequency.
5. If after 40 seconds the frequency search is not successful the product will perform a
warm reset.
6. If the operator would like to abort a search without waiting the 40 seconds, the
POWER key can be pressed to cause an immediate warm reset.
Note: The Front Panel will display “hunt” after a cold reset from the front panel. This
indicates that the product is in a Round Robin Hunt Mode. “hunt” will continue to be
displayed until the proper stream is detected.
In-Band Status
This diagnostic displays the in-band status for the last attempted tuned channel. The
information is updated every 5 seconds.