Replacing Lithium Batteries
http://www.motorola.com/computer/literature
1-23
1
To replace the on-board backup battery, follow the steps below.
!
Caution
Danger of explosion if battery is replaced incorrectly.
Replace only with the same or equivalent type recommended by the
equipment manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
Caution
Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Use ESD
Wrist Strap
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
to an electrical ground. (Note that the system chassis may not be grounded
if it is unplugged.) Secure the ESD strap to your wrist and to ground
throughout the procedure.
1. To remove the battery from the module, carefully pull the battery
from the socket.
2. Before installing a new battery, make sure that the battery pins are
clean.
3. Not the battery polarity and press the new battery into the socket.
Note
No soldering is required when the battery is in the socket.
4. Recycle or dispose of the old battery according to local regulations
and manufacturer’s instructions.
