Motorola CDM1250, Service & Installation Manual

Page: 7 / 32

October, 2004 6880309N15-A
v
CDM Control Station Foreword
Service Aids
Service Aids
The following table lists service aids recommended for working on the CDM Control Station.
Test Equipment
The following table lists test equipment required to service the CDM Control Station.
Motorola Part No. Description Application
HLN9214 Radio Interface Box Enables communication between the radio and the computer’s serial
communications adapter.
HSN9412 RIB Power supply Used to supply power to the RIB.
HKN9216 Computer Interface cable Connects the computer’s serial communications adapter to the RIB.
HKN9217 Program Test Cable RIB to Radio Cable
HVN9025 CDM-Series CPS Software on 3-1/2 in. diskettes.
Motorola Model No. Description Characteristics Application
R2200, R2400, or R2001 Service Monitor This monitor will substitute
for items with an
asterisk * Frequency/deviation meter and signal genera-
tor for wide-range troubleshooting and align-
ment
*R1049 Digital Multimeter Two meters recommended for ac/dc voltage
and current measurements
*S1100 Audio Oscillator 67 to 200 Hz tones Used with service monitor for injection of PL
tones
*S1053, *SKN6009,
*SKN6001 AC Voltmeter, Power Ca-
ble for meter, Test leads for
meter 1mV to 300V, 10-Megohm in-
put impedance Audio voltage measurements
R1053 Dual-trace Oscilloscope 20 MHz bandwidth,
5mV/cm - 20V/cm Waveform measurements
*S1350, *ST1215 (VHF)
*ST1223 (UHF) *T1013 Wattmeter, Plug-in
Elements (VHF & UHF),
RF Dummy Load 50 Ohm,
±
5% accuracy,
100 Watts, maximum
0-1000 MHz, 300 Watts
Transmitter power output measurements
S1339 RF Millivolt Meter 100uV to 3V RF, 10 kHz to
1.2 GHz RF level measurements
*R1013 SINAD Meter Receiver sensitivity
S1347 or
S1348 (prog) DC Power Supply 0-20 Vdc, 0-5 Amps Bench supply for 12.5 Vdc