Motorola CDM1250, Service & Installation Manual

Page: 10 / 32

1-2
6880309N15-A October, 2004
Introduction to the CDM Control Station CDM Control Station
Cables
CDM Control Station Interface Circuit
Boards
The Control Station contains three circuit boards and an
internal speaker that together provide the enhanced control
functions. The Control Station Interface Module (CSIM) is
the main board located beneath the radio inside the inner
chassis and mounted using card guides. This module con-
tains all logic, control, and interface circuitry. The Control
Station Audio Panel (CSAP) is located on the housing base
just behind the front panel. It provides the physical external
audio accessory connectors. The Control Station Key Panel
(CSKP) assembly is located on the front panel and provides
the buttons and LED indicators necessary for local dispatch
operation. A speaker is mounted to the front panel of the cab-
inet which allows for monitoring of radio receive audio,
accessory intercom, and accessory transmit audio.
Cables
The coaxial cables that connect the radio to the Control Sta-
tion back panel are fabricated from RG58A/U (the cable
used with most of the mobile antenna kits). Do not use
RG58A/U as the coaxial cable that connects the antenna con-
nector of the Control Station to the antenna. The rather small
size of the RG58A/U can introduce excessive losses in the
system that will decrease the effective range of the Control
Station.
Substitute RG400/U for short lengths and RG214/U or 1/2-
inch "hardline" for the longer lengths. If the "hardline" is
used, connect the antenna connector of the Control Station to
the end of the "hardline" with a flexible jumper cable. This
will avoid undue stress on the connectors of the cables and
the Control Station.
Table 1-1 can be used to determine which feedline to choose
for a given frequency band and line length to maintain 1.5 dB
(approximately 30%) or less power loss. Table 1-2 is a list of
Motorola part numbers for the various connectors and
cables.
D
esk M
ic
P1
S
upervisor
O
n
S
upervisor
O
ff
I
ntercom
Monitor
Transmit
H
eadset
P2
P3
CDM1550
P4
Figure 1-1. CDM Control Station
Table 1-1. Maximum Feedline Length in Feet (Meters)
Band RG400/U RG214/U Hardline
Low (50 MHz) 55 (17) 100 (30) 300 (90)
VHF (150 MHz) 25 (7.5) 50 (15) 150 (45)
UHF (450 MHz) 15 (4.5) 25 (7.5) 90 (27)
800 MHz 10 (3) 20 (6) 70 (21)
Table 1-2. Part Numbers for
Connectors/Cables
Part Motorola Part Number
mini-UHF male connector 2884606M01
UHF male connector 2884579F04