Motorola AT&T NVG589, Administrator'S Hanbook, Page: 46 / 216

Administrator’s Handbook
46
Link: Wireless
When you click the
Wireless
link the Wireless page appears. The Wireless page displays the status of your
Wireless LAN elements.
The Wireless page’s center section contains a summar y of the Wireless Access Point’s configuration
settings and operational status.
◆
The Wireless Operation function is automatically enabled by default. If you uncheck the checkbox, the Wire-
less Options are disabled, and the Wireless Access Point will not provide or broadcast its wireless LAN ser-
vices.
Summary Information
Field Status and/or Description
General Information
Wireless Operation May be either
On
or
Off.
Network Name (SSID) This is the name or ID that is displayed to a client scan. The default SSID for the
Gateway is
attxxx
where
xxx
is the last 3 digits of the serial number located on
the side of the gateway.
Hide SSID May be either
Off
or
On
. If On, your SSID will not appear in a client scan.
Security The type of wireless encryption security in use. May be OFF-No Privacy , WPA-
PSK
or
WEP
,
Default Key
or
Manual
.
WPA Version If WPA is selected, may be Both , WPA-1 , or WPA-2 ,.
WEP Key Length May be 10 characters for 40/64-bit, or 26 characters for 128-bit WP encryption.
Key Here you can enter a manual encryption key.
Mode May be 802.11 B only, 802.11 G only, 802.11 N , or 802.11 B/G/N .
Bandwidth The capacity of the wireless LAN to carry traffic in megahertz, 20 or 40 .
Channel The radio channel that your Wi-Fi network is broadcasting on.
Power Level May be adjusted up to 100%, lower if multiple wireless access points are in use,
and might interfere with each other.
Wireless Protected Setup
(WPS) May be either On or Off.