Motorola AP-7131N-FGR, Installation Manual, Page: 19 / 66

Hardware Installation 15
13. Verify the behavior of the access point LEDs. For more information, see LED Indicators on
page 21 .
14. The access point is ready to configure. For information on basic access point device
configuration, see Configuring “Basic” Device Settings on page 30 .
2.5.2 Suspended Ceiling T-Bar Installations
A suspended ceiling mount requires holding the access point up against the T-bar of a suspended
ceiling grid and twisting the access point chassis onto the T-bar.
The mounting tools (customer provided) and hardware required to install the access point on a ceiling
T-bar consists of:
• Safety wire (recommended and customer supplied)
• Security cable (optional and customer supplied)
To install the access point on a ceiling T-bar:
1. Motorola Solutions recommends you loop a safety wire — with a diameter of at least 1.01
mm (.04 in.), but no more than 0.158 mm (.0625 in.) — through the tie post (above the access
point’s console connector) and secure the loop.
2. If desired, install and attach a security cable to the access point lock port.
3. Attach the antennas to their correct connectors.
4. For information on the antennas available to the access point, see Antenna Options on page
6 .
5. Cable the access point using either the Power Injector solution or an approved line cord and
power supply.
For Motorola Solutions Power Injector installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host)
and the Power Injector Data In connector.
b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector Data &
Power Out connector and the access point’s GE1/POE port.
CAUTION
Ensure you are placing the antennas on the correct connectors to
ensure the successful operation of the AP-7131N-FGR access point.
!