8A
8B
EN
EN
05. PROGRAMMING
05. PROGRAMMING
DELETE ALL USERS
DOOR RELAY SHOOTING TIME
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Delete all users
Master Code
2
#
(This device allows you to delete all users recorded with card,
Fingerprint or both at once).
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Door relay shooting time
Pulse Mode (The activation time of the relay for door ope-
ning can be set between 1 and 99 seconds).
Close Mode
#
0
3
(Switching the relay tripping time on / off).
1 a 99 #
4
*
When used with an optional magnetic contact or magnetic contact built into the lock, if the door is
forced to open or is opened after 20 seconds, the internal bell and the alarm output will be active.
The alarm output time is adjustable from 1-3 minutes, the default time is 1 minute.
DOOR WARNING OPEN TOO LONG TIME (DOTL)
DOOR WARNING OPEN TOO LONG TIME (DOTL)
OPERATIONS
INSTRUCTIONS
•
Turn off the Alarm
OPERATIONS
INSTRUCTIONS
•
Turn off the Alarm
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Disable open door detection
(default).
#
0
6
•
Enable open door detection
#
1
6
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Set the alarm output time (Select be-
tween 1, 2 or 3 minutes).
#
(1~3)
5
When used with an optional magnetic contact or magnetic contact built into the lock, if the door is
normally opened but not closed after 1 minute, the internal doorbell will be active automatically to
remind people to close the door and continue to ring for 1 minute until it turns off automatically.
By default, Open Door Detection is disabled (60 #).
To turn off the alarm when it has been triggered, perform this step in Stand-By mode:
NOTICE OF FORCED DOOR OPENING
#
0
5
#
0
5
To turn off the alarm when it has been triggered, perform this step in Stand-By mode:
