9A
9B
EN
EN
05. PROGRAMMING
05. PROGRAMMING
If there are 10 invalid cards or 10 incorrect PINs within 10 minutes, the keypad will lock for 10 minutes
or the alarm and internal bell will be active for 10 minutes depending on the option selected.By default,
the Alarm is unlocked (54 #).
If you use an MLB2 as a Wiegand reader, you can set the ID of your device for recognition. When you insert
the valid Fingerprint, it will pass a virtual card number as the Wiegand 26 output path. For example, if
you set your device ID to 255 and the Fingerprint User ID is 3, it will virtual card number as 25500003.
The MLB2 can function as a wiegand output reader for the controller. Below the operations for adding
fingerprint users:
01
•
Add Fingerprint in MLB2
02
•
Operate the controller to enter the Add Card Users and read the Fingerprint added in the MLB2
corresponding to the User ID, it will generate a virtual card number and send to the controller to save
this number. So Fingerprint will be added successfully.
The MLB2 supports the lock function. It is two-way two-door device and used primarily for banks, prisons
and other places where top-level security is required.
01
•
Add Users to both MLB2
02
•
Set both readers to the lock function.
01
•
Turn off the power to the device.
02
•
Continuously press the Output Button connected to the MLB2 and reconnect the power to the device.
03
•
When you hear the "Di Di" alarm, release the Exit Button, the light will turn orange.
04
•
Pass one of the two master cards supplied in 10 seconds and the light will turn red.
The system has returned to factory settings.
Note that only the installer data is restored. User data will not be reset.
SETTING THE DEFAULT SETTINGS
THROUGH OPERATION
LOCKOUT OPERATION
CONFIGURE AN ID IN MLB2
CONFIGURE AN ID IN MLB2
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Alarm unlocked (by default)
#
4
5
•
Block for 10 minutes
#
5
5
•
Enable alarm, a Valid Card or Finger-
#
6
5
ALARM OUTPUT OPTIONS
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Set an ID in MLB2
#
(0~255)
7
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Set the Wiegand keyboard bits
#
(26~44)
7
•
Disable the Wiegand keyboard
These operations can only be done in
Programming Mode
.
OPERATIONS
INSTRUCTIONS
•
Enable lock function
•
Disable lock function
#
0
8
#
2
6
#
3
6
