Thomson
Thomson PC-Series™ Precision Linear Actuator - Installation Manual - June 2014
16
4.11.1 Motor installation on inline style models with RediMount system
1. Make sure the extension tube is fully retracted
and then remove the sealing plug.
2. Press the motor shaft on to the coupling inside
of the flange.
3. Bolt the motor to the flange using four screws.
Tighten the screws according to table T6.3.1.
4. Use a hexagon key to tighten the coupling
around the motor shaft. Correct tightening
torque for PC25 models = 0.85 Nm and for
PC32 and PC40 = 2.0 Nm.
5. Put the sealing plug back.