99
EN
Problem
Possible causes
Action
Trailer detection is not
working.
The trailer camera is not
displayed.
The cables installed
on the motor vehicle
and - or the trailer are
not suitable.
The “Trailer” function
is not configured.
Use Motec cable sets
MK553/661/660 or
MK84/85 or MK295
/296.
Configure the “Trai-
ler” function based on
the cable set used.
The camera image is
displayed the wrong way
round.
The mirror inversion
is not adapted to the
direction of view or
the installation positi-
on of the camera.
Configure the hori-
zontal and - or ver-
tical mirror inversion
in the main menu
separately for each
camera.
The rear view camera
can be switched off by
pressing the power but-
ton on the monitor.
The monitor can be swit-
ched off while reversing
(accident risk).
The control line
SEL-1 was not
connected to the
control signal for
reverse gear.
Use control line
SEL-1, as this has
the highest priority.
The side view camera is
displayed in the rhythm
of the direction of travel
indicator on the monitor.
The side view
camera is not con-
nected to the IN-2
video input.
The indicator function
(Indicator IN-2) is not
activated.
Connect the side
view camera to video
input IN-2.
Check Indicator IN-2
in the main menu.
Connect the SEL-2
and (if applicable)
POC control lines to
the indicator signal.
