9
PixlArt416 V1.0 User Manual V1.1
© 2018 Moss LED Inc.
Figure 5
Note:
Y
ou
can also
connect the
PixlArt416
directly to a PC.
4.2.3 - Forcing the Default IP Address
In the event that you forget the IP of a controller and you can’t see it in the Diode Manager, it
can be forced to its default IP. A simple procedure can be employed on power up:
1.
Hold down the “Factory IP” button
and power up the board
2. After a few seconds release the button. The controller
’s IP address
will now be 192.168.0.50.
You should now be able to setup your PC’s network settings to find the controller at this IP and
change the IP settings to what you prefer. After changing the settings or if you power the controller
off and on again, the controller will revert to using the saved settings.
