OPERATION
Page 16 of 23
!
!
WARNING: DO NOT ATTEMPT TO OPERATE HEATER UNTIL YOU HAVE READ AND
PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE.
Before turning gas supply ON
Your heater was designed and approved for OUTDOOR
USE ONLY. DO NOT use it inside a building or any other
enclosed area.
Make sure surrounding areas are free of combustible
materials, gasoline, and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or
servicing is replaced and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use,
and by a qualified service person at least annually.
If relighting a hot heater, always wait at least 5 minutes.
Lighting instructions
1) Turn the control knob to “OFF” position.
2) Turn LP cylinder gas valve to fully open position.
3) Push in the gas control knob and turn counter-clockwise
to “LOW” position, this will light the burner. If needed,
keep depressing and turning control knob
counter-clockwise until the burner lights. (You will hear 1
clicking noise).
4) Once the burner is lit, continue to keep the control knob
depressed for at least 30 seconds, then release control
knob.
FOR YOUR SAFETY:
If at any time you are unable to light
burner and smell gas, wait 5 minutes
to allow gas to dissipate before
attempting to light heater.
If after 1 minute, you are unable to
light burner, wait 5 minutes and allow
flammable vapors to dissipate before
attempting to light heater.
WARNING
FOR YOUR SAFETY:
!
WARNING
Allow emitter and dome to cool
before touching.
DO NOT touch or move heater
for at least 45 minutes after use.
!
WARNING
Lighting operations should comply
with Lighting Instruction section.
Improper lighting operations will
cause serious injury and explosion.
UNDERSTAND ALL PRECAUTION. FAILURE TO DO SO CAN RESULT IN SERIOUS
