The Specialist In Drum Handling Equipment
Model 410
Heavy-Duty Hydra-Lift, 72”, Manual Lift & Tilt
Operator’s Manual for Morse Heavy-Duty Hydra-Lift Karrier Model 410
Serial Number 1210 to ____ (MMYY)
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM410 (1210-____)
(Updated 24 Mar, 2022)
4
WARNING
- Watch Out for Pinch Points
Stay clear of moving parts. Operator should remain behind the
push handle during the lift operation.
Controls
The Morse Heavy-Duty Hydra-Lift Karrier is manually propelled and steered.
There are two functions for the operator to control (Figure 2.3)
1. LIFT and Lower Function
To raise the drum
•
Insert pump lever handle into pump socket.
•
With the release valve closed, begin to pump the lever handle. The drum will
lift.
To lower the drum
•
Open the release valve slowly, a part of a turn. Allow the drum to descend at
a controlled rate. The valve may be reclosed to hold the drum at any height.
2. TILT Function to control the degree of rotation of the drum.
•
Pull down on one side of chain, rotating drum to angle required for pouring.
•
The drum handler is equipped with the MORStop Tilt-Brake, there is no need
to hold tension on both sides of the chain loop. Braking is immediate and
self-actuating, without additional steps by the operator.
Figure 2.3
- - IMPORTANT - -
START-UP Procedure
Machine is shipped with hydraulic fluid.
BEFORE operation, REMOVE the
RED
shipping
plug from the hydraulic reservoir. REPLACE with
supplied
BLACK
breather.
Insert pump handle into pump socket.
Floor Lock
The step-down floor lock is located behind the base. To activate, step down on the floor lock until it locks in down position. When floor
lock is activated it prevents unwanted free wheeling of unit. Floor conditions determine effectiveness of floor lock. Operator should verify
its holding action before depending on it to hold.
Drum Holder
MORCINCH
TM
Drum Holder assembly (“saddle”) is the component on Vertical-Lift Drum Pourer intended to hold drum. Carriage assembly
moves vertically along mast to position drum holder assembly at correct height to secure drum around it’s middle using cinch chain and
ratchet tightening system. The MORCINCH
TM
Drum Holder accepts accessories to handle plastic drum, fiber drum, or a smaller diameter
drum.
