6
571823 - MX26HB Line Trimmer Owner’s Manual - April ‘14
Assembly
1. Insert the throttle wire through bracket and fasten by hex nut.
Fig. 3
2. Move the carburettor swivel toward the attachment.
3. Insert the tip (thick portion) of the throttle wire into the ground
hole of the swivel.
4. Close the carburettor cover by fastening the screw. Fig. 3
5. Connect 2 lead wires from the throttle trigger to the
corresponding 2 wires from the engine. Fig.6
THROTTLE WIRE MOUNTING
Pass the throttle wire through adjust screw
as Fig.3.
LEAD WIRE
As Fig. 6, one lead wire which is from the
throttle trigger to mount with stop switch wire
which comes from the engine.
HANDLE
1. Adjust loop handle joint to most
comfortable position for user.
2. Attach joint loop handle with main pipe.
Fig. 2
3. Fasten 4 sets of screws with hex nuts
tightly.
SAFETY GUARD
Put the safety guard on the shaft tube near
the gear case, attach it with the screw, washer
and nut provided.
Do not operate this unit without a safety guard, if the safety
guard is damaged replace immediately. Do not continue with
a damaged guard.
INSTALLING THE NYLON CUTTER HEAD
1. Make sure the inner flange is fitted correctly on the gear shaft
and turn it until it can be locked in position with the ‘L’ shaped
locking bar inserted through the outer shroud.
2. Screw the nylon cutter head clockwise onto the shaft.
3. Use the ‘L’ shaped bar to prevent the inner flange from turning
while screwing the nylon cutter assembly onto the shaft.
Hand tighten only.
Fuel
1. Petrol is very flammable. Avoid smoking or
bringing any flame or sparks near fuel.
2. Wipe up all spills before starting the engine.
3. Stop the engine and allow it cool before
refuelling the unit.
4. Keep open flames away from the area where
fuel is handled or stored.
Operating
BEFORE STARTING THE ENGINE
Check for loose screws and nuts and fill with proper mixed fuel. For
safety, please place the engine on stable ground with engine stand
(fuel tank) and the guard down.
STARTING A COOL ENGINE
1. Push the priming pump 5 times, Fig.7
2. Fully close the chock, Fig.8
3. Hold the handle and depress the throttle trigger to the end.
Release the throttle trigger upon pushing the throttle lock
bottom first on the handle.
4. Set the switch to ON position. In the opposite direction to the
arrow mark with OFF Fig. 9
5. While holding the trimmer firmly by hand at the shaft assembly
near the engine, pull the starter strongly.
6. When ignition is heard, open the choke lever gradually and
release the starter. Fig. 10
7. Warm up the engine for about 3 minutes.
E
FUEL
FLAMMABLE
FUEL
