RELAY DRIVER
30
The channel is now configured for GenStart. The Relay Driver
Setup screen should display the GenStart Function parameters
in the Configuration Summary for the channel.
If all four channels are configured as desired, refer to section
3.3 for instructions on how to program the Relay Driver.
GenStart
Advanced
Setup Definitions
The following definitions can be used when configuring the
Alarm/Fault Function in
Advanced
setup. These values are
assigned the appropriate default values in
Simple
setup.
Control Address
– the meter bus ID for the device that is to be
monitored. Factory default is one (1) for the TriStar and nine (9)
for the Relay Driver. (Not applicable in Standalone)
Maximum On Time
– maximum generator run time
Minimum On Time
– minimum required generator run-time
before shut down
Maximum Off Time
– maximum period of time before forcing a
run cycle (maintenance cycle)
Minimum Off Time
– minimum period of time off before
allowing another start
Summary of Contents for RelayDriver
Page 9: ......
