Page 12
Operation 12. 21. ’04
Easy Operation
Press the Power switch to turn the unit on and press the Mode switch to select any one of three
memories.
Each memory can be set for different motor control parameters. The desired set of parameters can
be easily selected by pressing Mode switch button.
Manual Operation
Foot switch allows the file to rotate outside the root canal. The file can rotate manually even without
the foot switch when the unit is set in manual mode. The file rotation can also be reversed manually
when the file is engaged too deeply in the root canal. (Use caution when using this function as the
file reverses at a considerable rate of speed and torque.)
Root Canal Measurement (Two Methods)
Plug the probe cord into Canal Measurement Module and connect the file
holder and contrary electrode.
1.
Leaving the micromotor connected and press the Mode
switch until the speed and memory displays disappear.
(Refer to the operation manual for Canal Measurement
Module.)
2.
Detach the micromotor from handpiece cord. Select M1,
M2 or M3 with pressing the Mode switch and measure
length of a root canal. (Refer to the operation manual
for Canal Measurement Module.)
WARNING
•
When measuring the length of a root canal, make sure that the file electrode does not come
into contact with an electric power source such as an electrical socket. This could result in a
severe electrical shock.
•
Before measuring length of a root canal, make sure that the rotation speed does not appear on
the display. If the rotation speed appears on the display, the unit is set for root canal
preparation mode, and the handpiece will operate.
NOTE
•
It is best to disconnect the handpiece when measuring the root canal.
•
Remove the file from the micromotor when taking a measurement.
Rotation speed is
not displayed.
Probe Cord Plug
Memories are not displayed.
Rotation speed is
not displayed.