Morita Lubrina HIM-1, Operation Instructions Manual, Page: 25 / 40

Operation 2006-02-21 23
1. Turn the main switch on.
2. Hold down the Start Switch (Start / Stop / Set Switch) and
then hold down a Selector Switch for 2 seconds.
Release it when a beep sounds.
The Selector Lamp will blink to show that you can now
change its setting.
3. Now press the Selector Switch to change modes.
Each press of the Selector Switch will change the modes
in sequence.
* The lamp’s blinking rate will change.
4. Check the time setting by how fast the lamp blinks, and
then press the Start Switch for 2 seconds.
A double beep signals that the change has been made.
After this the lamp goes out.
♦ Each Select Switch must be set separately using the above
procedure.
Start Switch
Selector Switch
Short Long
Long
Blow-out