Operator Manual
DigiBook 150
42
Rev. 1.00-C
Basic principles:
1. It is necessary to stay in the start-up page to be able to produce books (see previous image)
2. Put the book into the clamp
3. Close the clamp using the specific handle. If the clamp is not closed a dedicated sensor does
not allow the machine to start the cycle and leave the machine in alarm.
4. Press together the buttons on the front side of the machine and hold them until the carriage
is not on the press. If you release one or both buttons, the machine stops and goes into alarm
status. In this condition it is compulsory to remove the book from the clamp and do the pre-
set of the machine.
5. The press automatically comes up.
6. Open the clamp as indicated by the display. If the clamp does not open, the machine does
not allow the carriage to go back. Due to the sensitiveness of the sensor, it can happen that
with big thickness books (50 mm) the sensor keeps reading that the clamp is not opening. In
this case after open it, press the button OK in order to allow the carriage to return in posi-
tion.
7. Press the right button and hold it to make the carriage to go back. If you release the button
while the carriage is going back in loading position, the machine stops and goes into alarm
status. In this case it is necessary to remove the book from the clamp and do the preset of the
machine.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
