Moretti MOPEDIA RC325-40, Instruction Manual

Page: 24 / 48

8
ENGLISH
10.6 Brakes
FIG. 13 FIG. 14 FIG. 15
On model RC325-xx, the brakes are operated by pressing the lever on the rear wheels of the
chair
(FIG. 13). On all the other models, the brake is activated by pressing on the lever as far
as it will go (FIG. 14 and 15).
If adjusted correctly, the brake lever must be firmly gripped around the wheel, i.e. it should
penetrate around 5 or 6 mm into the rubber. If it is not, check the tyre pressure. If necessary,
adjust the brakes by loosening the locking nut, using the wrench provided, and allow the clamp
to slide forwards or backwards, according to need. Tighten the locking nut completely.
10.7 Wheels
FIG. 16
FIG. 17
Check the wheels periodically and lubricate if necessary. Remove the fork by unscrewing the
bolt and lubricate the pin
(FIG. 16) .
Also remove the wheel from the fork and lubricate the pins. Assemble the wheel and fork again
by tightening the screws until there is no clearance, but the wheels rotate freely. On models
RC340-xx and RC345-xx, the large wheels with diameter Ø 600 mm must be checked
periodically and must not wobble. If the wheel wobbles, tighten the pin nut slightly
(FIG. 17) .
To test the wheel, incline the commode chair to one side and turn the wheel. The wheels do not
require inflation and are puncture-proof, as they are solid wheels.
10.8 Armrests
FIG. 18
To remove the armrests, press down on the lever (front clasp) and
pull the pin using the special grip (rear clasp), then raise it
(FIG.
18) .
10.9 WC
FIG. 19 FIG. 20
Use the WC with the chair fully braked.
For use of the WC, extract the removable
part of the seat by pulling the handle
on the front
(FIG. 19). Extract the WC
from the back by pulling on the grip
(FIG. 20).