6
To fill the water tank,
1.
Remove the top cover by pulling straight up,
Fig. 1.
Remove the medicine cup if applicable.
2.
Select either tap or distilled water* that has a
temperature range of 20° F - 30° F ,
Fig. 2.
*
Distilled
water is preferred.
3.
Fill the water reservoir with tap or distilled water to
the indicated level (between the 2 lines located
inside the water reservoir),
Fig. 3.
Remember: Do not use solutions other than
water
in
the reservoir. It may damage the transducer -
Fill to the correct level.
Note:
·
·
The use of cool water (below 68°F or 20°C) will result in a lower rate of
nebulization.
·
·
The use of warm water (above 86°F or 30°C) will result in a
higher rate of nebulization.
To fill the medicine cup,
1.
Place the medicine cup inside the water reservoir.
2.
Pour the medicine directly into the medicine cup.
3.
Replace the top cover.
Remember:
·
· The maximum capacity of the medicine cup is 8 ml. and should not be
overfilled.
·
· Dilute dense medications or medication volumes 2 ml. or less with distilled water
or saline solution to obtain a volume of at least 4 ml.
·
· Only use medications under the instructions of your physician.
To connect the AC adapter,
1.
Insert the adapter plug into the unit's AC port,
Fig.4.
2.
Plug the adapter into a standard AC outlet.
F
IG
.1
F
IG
. 2
F
IG
. 3
WATER BETWEEN
THESE TWO LINES
MA LT155_160 01A.qxd:Manuale Istruzione Aerosol.qxd 4-12-2008 16:16 Pagina 19