Class Medical Device according to EEC directive 93/42
& subsequent amendments
Codes
RS970/30
ø
32 mm length
30 cm
RS970/45
ø
32 mm length 45 cm
RS970/60
ø
32 mm length 60 cm
RS972/30
ø
36 mm length 30 cm
RS972/45
ø
36 mm length 45 cm
RS972/60
ø
36 mm length 60 cm
Introduction
Thank you for choosing a MOPEDIA plastic safety bath handles from the
MOPEDIA by MORETTI S.p.A. product range. The design and quality of these
products is a guarantee of comfort, safety and reliability. MOPEDIA by MO-
RETTI S.p.A. plastic safety bath handles are designed and built to meet all
your demands for practical, correct use. This user’s manual provides some
suggestions as to how to correctly use the bath handles you have chosen
and gives some valuable advice for your safety. Please read through the
manual carefully before using the plastic safety bath handles. Should you
have any queries, please contact your retailer for advice and assistance.
Intended use
The MOPEDIA safety bath handle by Moretti is a bathroom aid for peo-
ple with motor difficulty.
EC Declaration of conformity
MORETTI S.p.A. hereby declares, under its own exclusive responsibility, that
the products manufactured and sold by MORETTI S.p.A. and belonging to
the PLASTIC SAFETY BATH HANDLES category are compliant with the ap-
plicable provisions outlined in the Medical Devices Directive 93/42/EEC. To
this end MORETTI S.p.A. guarantees and declares as follows, under its own
responsibility:
1.
The devices in question satisfy the essential requirements of Annex I of
ENGLISH
ENGLISH
directive 93/42/EEC as prescribed by Annex VII of the said directive.
2.
The devices in question ARE NOT MEASUREMENT TOOLS.
3.
The devices in question ARE NOT INTENDED FOR CLINICAL INVESTI-
GATION.
4.
The devices in question are sold in NON STERILE packing.
5.
.The devices in question should be considered as belonging to class I.
6.
DO NOT use/install the devices in question for any other purpose than
that expressly indicated by MORETTI S.p.A.
7.
MORETTI S.p.A maintains and submits the documentation certifying con-
formity with Directive 93/42/EEC to the proper authorities.
Assembling
- Choose a solid and safe wall to install the handle.
- Make sure that it is possible to drill the wall safely for people and things.
- Make sure to position the handle bar at the most suitable height for
users.
- Lift the flange cover to show the hole screw.
- Offer the handle up to the wall in the desired position and mark the screw
hole position.
- Drill the wall and push correct sized plugs for the screw you are using into
the wall.
- Offer the handle up to the wall, and drive the screws (we recommend using
stainless steel countersunk screws 5x50mm).
- Tighten well the screws.
- Finally, clip the screw cover over the flanges. This will give to your handle
an elegant appearance and hide the screw head.
NOTE
STAINLESS STEEL SCREWS ARE RECOMMENDED TO REDUCE
THE RISK OF RUST
MA RS970-xx_972-xx 01 A.indd 4
13/07/11 16.40
