Mopec Maestro MB1000 Series, Installation, Service And User Instructions Manual

Page: 44 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 44
Water Fixture Failures
My station’s faucets do not
work
Facility water turned “OFF” Turn “ON” facility water supply
Mixing valve (pressure/temp
control turned “OFF”
Turn mixing valve “ON”
Water system plugged
Check Y Strainers for debris
Check for kinked supply lines
Check backflow prevention devices
(REF 8.2.5)
My foot pedal will not cause
water to dispense
Mixing valve (pressure/temp
control turned “OFF”
Turn mixing valve “ON” and leave “ON”
Water timer set to “0”
minutes
Set water timer to 1 minute or above (REF 6.2.6)
Foot pedal air hose
Disconnected from Air switch
Re-connect Air hose to Foot pedal or Air switch
(REF 8.2.3.4)
My hand rinse or end rinse are
not working
Hand spray hose kinked
Un-kink hand spray hose
Check in lower skirting for interference
Mixing valve “OFF” Turn mixing valve “ON”
Gate valve for end rinse “OFF” Turn gate valve “ON”
Water system plugged
Check Y Strainers for debris
Check for kinked supply lines
Check backflow prevention devices
(REF 8.2.5)
Station is leaking water
Leak at facility connection
Check strainer drain plug
Check flex lines from strainer
Check drain line connection
Check P-trap to facility connection
Leak internal to station
Shut off all mixing valves and turn off hot/cold
separately to isolate leak circuit
(REF 9.3)
Service water lines & connections (REF 9.3)
LIGHTING
No lights will come on G.F.C.I. has been tripped Reset G.F.C.I. (station power must be “ON”)
Individual 7” overhead light not
working
Bad Light driver or loose
connection at driver Check for loose connection at driver, replace if
necessary
LED failure Replace LED light
Surface light not working
Surface light not turned “ON”
in touch screen Turn surface light “ON” in touch screen lighting
menu