7
TSM14POE Hardware Manual
920-0153 A
01/23/2020
2 Getting Started
The following items are needed:
• A POE+ rated Ethernet switch or injector.
Recommended:
- Injector: BV Tech POE-I100G (Applied Motion P/N 1000-382).
- Switch: BV Tech POE-SW801.
• A PC running Microsoft Windows XP, Vista, or Windows 7 or 8 or 10. 32 or 64 bits.
• A CAT6 network cable (not included).
2.1 Installing Software
Before utilizing the TSM14POE StepSERVO Integrated Motor and Step-Servo Quick Tuner
Software in an application, the following steps are necessary:
• Download and install the Step-Servo Quick Tuner software.
•
If you intend to connect the drive directly to your PC, configure your computer to use IP
address 10.10.10.11. (For instructions on connecting your TSM drive to a local area network
(LAN), please consult the appropriate hardware manual).
• On the TSM drive, select switch position 0, which will assign IP address 10.10.10.10. (See the
hardware manual for further details on selecting IP addresses for the drive and PC).
• Launch the software by clicking: Start / All Programs / Applied Motion Products / Step-Servo
Quick Tuner or use the desktop shortcut.
• Connect the TSM to the injector or power switch using a Ethernet cable.
•
Click “Connect” in the software. The drive model and firmware revision should be
automatically displayed in the Step-Servo Quick Tuner software.
2.2 Mounting the Hardware
As with any step motor, the TSM14POE must be mounted so as to provide
maximum heat sinking and airflow. Keep enough space around the Integrated Motor
to allow for airflow.
•
Never use the drive where there is no airflow or where other devices cause the
surrounding air to be more than 40°C (104°F).
• Never put the drive where it can get wet.
• Never use the drive where metal or other electrically conductive particles can
infiltrate the drive.
•
Always provide airflow around the drive.
