11
PAGE 5: CLOCK OUTPUT PPQN (Pulse Per Quarter Note)
Here you can set the number of outgoing clock pulses that will equal one quarter note.
NOTE:
24 PPQN is used by the DIN SYNC standard; 48 PPQN is used by some older drum machines
PAGE 6: SAVE MODE
This page allows you to specify the Save mode for your Mother-32. The full descriptions of each mode can
be found under the SAVING A PATTERN section of this manual.
PAGE 7: [RESERVED]
There are no user accessible parameters on this Page.
PAGE 8: ON / OFF PARAMETERS
The parameters available on this page can be toggled On or Off so that your Mother-32 will behave in a way
conductive to your creative process.
1:
1 PPQN
2:
2 PPQN
3:
3 PPQN
4:
4 PPQN
5:
5 PPQN
6:
6 PPQN
7:
7 PPQN
8:
8 PPQN
9:
9 PPQN
10:
10 PPQN
11:
11 PPQN
12:
12 PPQN
13:
13 PPQN
14:
14 PPQN
15:
24 PPQN
16:
48 PPQN
1:
Manual Save mode
2:
Auto Save mode (added in Version 2.0)
3:
Write Protect mode (added in Version 2.0)
1:
Follow MIDI Clock (On / Off)
2:
Follow MIDI Start Stop (On / Off)
3:
Clock Output Swing (On / Off)
4:
Accent Out CV Only
ON:
The internal Accent circuit is disabled when the
ASSIGN
Output Jack is set to Accent (Page 1;
Parameter 1).
OFF:
The internal Accent circuit is enabled.
5:
Tempo Input Range
ON:
The voltage range of the
TEMPO
input is 0V to +5V
OFF:
The voltage range of the
TEMPO
input is -5V to +5V
6:
Delay Pattern Change
ON:
When a new Pattern is selected, the sequencer will finish playing the current pattern before
switching to the new pattern
OFF:
When a new Pattern is selected, the sequencer will begin to play the new pattern
immediately.
7:
Load Saved Timing
ON:
When a new Pattern is selected, the timing settings (Clock Division, Swing Interval, and
Swing Amount) that were saved with the pattern will be restored.
OFF:
When a new Pattern is selected, the previously-active timing settings will remain unchanged.
MOTHER-32 FIRMWARE UPDATE V2.0
April 2020
