- 5 -
WINDOW GUARD™ PAINT SHIELD REPLACEMENT
Your Warrior 6 comes with a replaceable Window Guard™ paint
shield to protect the front plate window from vandalism. If vandalism
occurs (spray paint, scratches, etc.) you need only replace the shield,
not the entire window. Additional shields can be ordered. To replace
the shield, use the following directions.
1. Remove the face plate.
2. On the inside of the face plate, remove the (4) 6-32 nuts
holding the window in place (Figure 14).
3. Remove the damaged paint shield.
4. Place a new shield in front of the window. Reinstall the window,
making sure to securely tighten the (4) nuts. Reinstall the face
plate.
Figure 14
Window
Window Guard™
Paint Shield
COMPLETION OF INSTALLATION
Reattach the front plate to the back box and tightly fasten the (3)
security screws using the security tool.
ADDENDUM 1
The cameras included in the Warrior series are able to transmit video
signals to NVT receivers via unshielded twisted pair cable. You must
purchase the receiver separately. Instructions for connecting the
receiver end of the unshielded twisted pair cable will be included
with the NVT receiver. Following are instructions for connecting the
unshielded twisted pair cable to the PC board inside your Warrior
housing. See the TROUBLESHOOTING section in the back of these
instructions if you experience any problems.
UNSHIELDED TWISTED PAIR
VIDEO WIRING
1. Connect the unshielded twisted pair cable to the positive and
negative screw terminals on the Warrior PC board (Figure 15).
2. Connect the other end of the unshielded twisted pair cable to the
NVT receiver.
CAUTION:
The unshielded twisted pair video signal is polarity
dependent. The positive video terminal on the
Warrior PC board MUST be connected to
the positive terminal on the NVT receiver, and
negative MUST be connected to negative.
3. When using unshielded twisted pair cable you DO NOT need the
BNC connector. Be sure that there is no video connection other
than the unshielded twisted pair cable.
Video Negative (-)
Video Positive (+)
Figure 15
NOTE:
The customer must purchase the Video Transceiver from
NVT. Part numbers are:
• NV-212A (500 ft.)
* NV-213A or NV-213A-M (1000 ft.)
• NV-652R, NV-862R, or NV-1662R (3000 ft.)
PC Board
