- 7 -
SHOW
- Allows the title to be displayed. Press "zoom in" to
turn this on, "zoom out" to turn it off.
PRIVATE
- Determines if this will be a privacy zone. Press "zoom
in" to turn this on, "zoom out" to turn it off.
RLIMIT
- Sets the pan right limit for the zone. The current pan
limit will be displayed. Press "zoom out", the picture will reappear
and you will have pan control. Pan to the desired location. Press
"zoom in" to select. The new pan limit will appear.
LLIMIT
- Sets the pan left limit for the zone. The current pan limit
will be displayed. Press "zoom out", the picture will reappear and
you will have pan control. Pan to the desired location. Press
"zoom in" to select. The new pan limit will appear.
NOTE: The picture will displayed whenever you are in RLIMIT
or LLIMIT. When you toggle to any other sub-menu the
picture will disappear.
CAMERA -
The “CAMERA” sub-menu is used to control several of
the camera’s parameters. PAN RIGHT to access the sub-menu. TILT
DOWN to access each item.
NOTE:
When this sub menu is accessed the camera picture will
return to allow adjustments.
STABILIZER
- Stabilizer, where equipped, compensates for small
movements or vibrations when the camera is “zoomed in”. Press
"zoom in" to turn this on, "zoom out" to turn it off.
DAY/NIGHT
- This is used to control the low light mode of the
camera. There are three choices:
AUTO - The camera will automatically switch into day/night
mode for low light conditions.
DAY - The camera will be in the day mode continuously.
NIGHT - The camera will be in the night mode continuously.
Press "zoom in" to cycle through the choices. P
SHUTTER
- Selects between auto and manual shutter speeds.
Press "zoom in" to cycle up through the selections, or "zoom out"
to cycle down.
BACKLIGHT
- Controls backlight compensation. Press "zoom in"
to turn this on, "zoom out" to turn it off.
AGC
- Selects automatic AGC or minimum AGC (0db). Press
"zoom in" to turn this on, "zoom out" to turn it off.
DIGI ZOOM
- Turns the digital zoom on and off. Press "zoom in"
to turn this on, "zoom out" to turn it off.
ALARM -
To get to this section, tilt down from the CAMERA menu.
This menu allows the user to control the operation of the alarm input.
If the alarm is enabled, the camera will go to preset 1. Press "zoom
in" to enable, press "zoom out" to disable.
ZONES -
Up to 16 zones may be selected, each zone has a number
of parameters associated with it. Pan Right to access Zones. "ZONE
1" will display.
"Tilt up" or "Tilt down" to select the zone desired. Once the zone is
selected, "Pan Right" to access the sub-menu.
TITLE
- Displays the current title.
SET TITLE
- This is used to set the title of the zone. The current
zone title will be displayed at the bottom of the screen with at
question mark (?) at the cursor position. Use pan right or left to
change the cursor position. When the desired position has been
selected, use tilt up and tilt down to select the character to be
displayed. Press "zoom in" to set the title and exit the submenu.
Pressing "zoom out" will restore the original title.
TEMP
- This displays the temperature sensor data on the tilt
board. Press "zoom in" to turn this on, "zoom out" to turn it off.
NOTE:
This reading will be higher than the actual ambient
temperature in the dome. This is for diagnostic use only.
PRESSURE
- This displays the pressure sensor data for units
equipped with a pressure sensor. Press "zoom in" to turn this on,
"zoom out" to turn it off.
