Page 9
Page 9
Page 9
Page 9
Page 9
E38-PV Gas Fireplace
Part No. XM0500
Installation
Installing the Log Set
Installing the Logs:
The
E38-PV
is supplied with five (5) fibre logs. Logs 'A' and 'B' are
factory installed on the mounting slots. They should be positioned as
shown in figure 15a. Place logs
"C"
,
"D" and "E"
onto the mating
positions as shown below in figure 15b
.
Figure 15b.
Completed log installation. Logs 'D' and 'E' are placed in
their mating positions, and embers are in place.
Placing the Embers:
The
E38-PV
is supplied with a small bag of embers. Place the ember
material along the middle of the burner between the flame shaper and
log 'A'. Do not let the ember material fall behind the burner tube.
Embers
Log 'D'
Log 'E'
Flame Shaper
Figure 15a.
Log 'C' is positioned in its mating position with the'y'
toward the back of the fireplace. Logs 'A' and 'B' shown in
factory-installed positions.
Log 'A'
Log 'C'
Log 'B'
NOTES
:
n
If logs are not placed properly, excessive sooting will result.
n
The surface of the logs will crack due to the heat from the
flames. This is a normal occurance.
Figure 14a.
Wiring for optional air circulating fan kit.
G
L1-WH
L2-BLK
Quick Connect
plug to motor
NOTE:
If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
Figure 14b.
Wiring schematic for optional fan kit.
115/1/60 Supply
G
L1 L2
Fan Wiring
Wiring for the
optional
Fan and Blower Kits
All 38 Series fireplaces may be equipped with optional fan or blower
kits for circulating heat into the living space.
Installations in Canada
which employ the fans must be electrically
grounded in accordance with
CSA C22.1
Canadian Electrical Code
Part 1 and/or Local Codes.
Installations in the USA
which employ the fans must be grounded in
accordance with local codes or, in the absence of local codes, with
the National Electrical Code,
ANSI/NFPA 70-1987.
For more information see the
Fan Kit Installation Guide
included
with the fan kit.
