Monster MPC 100M, User Manual

Page: 6 / 16

ENGLISH
6
FCC NOTICE
FCC ID: Y4B-AIC-EGW
(for PowerControl ™ Gateway)
FCC ID: Y4B-MST-RFM
(for PowerControl 100M / 100MC / 300MC)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced
radio/TV technician for help
FCC Warning
Changes or modifications not expressly approved
by Monster Cable Products, Inc. could void the
user’s authority to operate the equipment.
FCC Radiation Exposure Statement
To comply with FCC RF exposure compliance
requirements, the antenna used for this
transmitter must be installed to provide
a separation distance of at least 20 cm from
all persons and must not be co-located or
operating in conjunction with any other
antenna or transmitter.
FCC Modular Approval Statement
This equipment is sold only to OEM integrators
and must be installed by the OEM or OEM
integrators under the following conditions:
1. The antennas used for this transmitter must
be installed to provide a separation distance
of at least 20 cm from all persons and
2. The transmitter must not be co-located with
any other antenna or transmitter.
FCC Label
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.