68
Firmware Update
You can update the firmware for the Monster
®
GO-DJ
™
by following
these directions:
•
Download the latest firmware from the Monster
®
GO-DJ
™
official website
(www.monsterproducts.com/godj).
•
Connect the Monster
®
GO-DJ
™
to a computer using the USB cable.
•
Place the firmware update file on the internal drive (GO-DJ Drive) or SD card.
•
Disconnect the Monster
®
GO-DJ
™
from the computer.
•
From the SYSTEM menu, slide the UPDATE switch.
Mandatory Firmware Update
If it is impossible to update the firmware from the SYSTEM menu, please run a
mandatory firmware update using the Firmware Recovery Menu. The Recovery
Menu starts when corruption of a firmware file is detected, and you can also
manually start it by following the steps below:
Preparation for Mandatory Firmware Update
•
Download the latest firmware from the Monster
®
GO-DJ
™
official website
http://monsterproducts.com/godj.
•
Place the file to an SD card using an SD card writer.
•
Insert the SD card to the SD card slot of the Monster
®
GO-DJ
™
.
Starting the Recovery Menu
•
Remove the USB cable if connected.
•
Press the RESET button located at the back side of the Monster
®
GO-DJ
™
using a pointed object such as pen.
•
Hold VOLUME-A, FX-LEVEL, VOLUME-B knobs down together and turn
the Monster
®
GO-DJ
™
on simultaneously.
•
When a firmware update screen shows, move the crossfader from the left
to the right. If the crossfader is not moved correctly from the left to the right
within 10 seconds, the Monster
®
GO-DJ
™
will attempt to boot normally.
Please note:
In the case that the Recovery Menu Screen does not show up,
please repeat the directions starting with the pressing of the RESET button.
FIRMWARE
Summary of Contents for Go-DJ
Page 1: ...Manual and Warranty...