STEP 3
Remove the segment, leaving the bracket in place on the wall.
Press firmly
on the bracket for 10 seconds to ensure a strong hold.
NOTE:
If you ever want to uninstall your Digit segment in the future, simply hold
the bracket and SLOWLY stretch the damage-free removal tab down along the
wall to remove. It can be reinstalled with new 3M strips (rated at least 3lbs).
IMPORTANT:
• Plan to install your Digit near enough to a power outlet.
• Place the controller somewhere on the bottom of your pattern.
• To ensure all segments light up, make sure all the connector
cables always point GREEN side
AWAY
from the controller.
• Only one
GREEN
plug should ever be connected a single segment.
PRESS FIRMLY
for 10 sec
STEP 4
Attach the controller and connector cables to your first segment as
desired to build your pattern. Plug the
green
controller cable in and
ensure all other cables are connected
RED side in
and
GREEN ends
pointing out
. Make sure to insert each connector fully into the port.
(damage-free
removal tab)
(example)
remember your
design idea
GREEN always
points AWAY
from controller
RED always
points TOWARDS
controller
HOW TO USE
the connector
cables:
TIP:
Only one green plug
should ever be connected to
a single segment at a time.
5
6
