8
TROUBLESHOOTING
Symptom
Possible Cause
Remedy
The Signature
PRO AVS 2000 is not
receiving power.
The Signature PRO AVS 2000
is not turned On.
• Make sure the Signature PRO AVS 2000’s AC
power plug is plugged into a properly grounded
120V wall outlet.
• Press the ON button on the Signature PRO AVS 2000.
• In some households, a wall switch may need
to be thrown to make the wall outlet come alive.
Try turning on the light switches located near the wall
outlet powering the Signature PRO AVS 2000.
Too many devices are connected,
causing an overload, tripping the
thermal circuit breaker.
Please note:
The total power consumption on
all the components powered by
a single Signature PRO AVS 2000
should not exceed 3680 watts
continuous or 4000 watts peak.
• Disconnect any component that maybe overloading
the Signature PRO AVS 2000.
• Press the Signature PRO AVS 2000’s thermal circuit
breaker (labeled Breaker 15A on the back panel)
button in to reset. Please allow 10 minutes from
the time the circuit breaker is initially tripped before
attempting to reset. If you reset too soon, the breaker
will prematurely sense power overload and not allow
the unit to operate.