9
Output Resolution Reset
Press and hold the OUTPUT RES button for at least 5 seconds to reset the output resolution
to 720p.
Display Control
Press the DISPLAY ON and DISPLAY OFF buttons to turn the connected display on or off.
Note that the system must be configured to issue the proper CEC commands to the
connected display. See the
CONFIGURING DISPLAY CONTROLS section for details.
RS-232 CONTROL
This switch features an RS-232 connector with the ability be controlled by a third party RS-
232 control software, as well as to pass RS-232 control signals through to a third party
HDBaseT™ matrix or receiver (not included). It supports serial communications rates of
2400, 4800, 9600 (default), 19200, 38400, 57600, or 115200 baud.
To use RS-232 control, plug one end of the included RS-232 cable in to the RS232 Euroblock
connector on the switch, then plug the other end into an available serial port on your
computer. The RS-232 communications protocol is as follows:
Baud Rate: 9600 (default)
Data Bits: 8
Stop Bits: 1
Parity: None
Download and install a third party RS-232 control software, such as
CommWatch.exe, whose interface is shown below as an example.