8
CONTROLS
Manual Switching
Momentarily press the SOURCE/AUTO-3s button to switch to the next available input. The
corresponding LED will illuminate green. If Auto Switching is enabled, this will turn it off
and the AUTO LED will extinguish.
Auto Switching
Press and hold the SOURCE/AUTO-3s button for at least 3 seconds to turn Auto Switching
on. The AUTO LED will illuminate green. Auto Switching abides by the following principles:
New Input: When a new source is detected, the unit will automatically switch to the
new input.
Rebooting: The unit saves its status and will automatically enter the last mode used,
in the event that power is lost. If the last displayed signal is still available, the unit
will switch to that input. Otherwise, the unit will scan the inputs in order (1-4), then
will switch to the first input found.
Signal Loss: If the currently displayed signal is lost, the unit will scan the inputs in
order (1-4), then will switch to the first input found.
Volume Control
Use the VOLUME UP and VOLUME DOWN buttons to adjust the output volume level.
Output Resolution Selection
Momentarily press the OUTPUT RES button to display the
OSD Resolution Menu. Momentarily press the OUTPUT RES
button again to move the highlight down the list. Once the
desired output resolution is highlighted, press and hold the
OUTPUT RES button for at least 2 seconds to set the output
resolution to the highlighted value.