9
green. Note that the green LED will override other LED indications while Multipoint
Mode is active.
RECEIVER (RX) MODE OPERATION
Bluetooth Pairing (RX)
Perform the following steps to pair the receiver with a Bluetooth® device, such as a mobile
phone or tablet.
1.
If the unit is powered on, press and hold the POWER button for about 2 seconds to
turn it off. The LED will flash red twice.
2.
Wait at least 3 seconds, then slide the TX/RX switch to the RX position.
3.
Press and hold the POWER button for about 2 seconds to turn the unit on. The LED
will flash blue twice.
4.
Momentarily press the PAIR button. The LED will rapidly flash red and blue
alternately, indicating that the receiver is in Bluetooth pairing mode in RX mode.
5.
Open the Bluetooth settings on your mobile device and scan for available Bluetooth
devices. Locate and select the BTI-039 entry. If prompted for a pass code, enter
0000 (four zeros). Once connected, the LED will begin to slowly blink blue.
6.
Connect your audio playback device, such as powered speakers or a power
amplifier, to the receiver using either the included 3.5mm audio cable or the
included S/PDIF digital optical cable. If using an S/PDIF cable, use the SPDIF RX
output.
Multipoint Pairing (RX)
Perform the following steps to pair the receiver with two Bluetooth® devices, such as
mobile phones or tablets.
1.
If you have not already paired a single device, preform the steps in the
Bluetooth
Pairing (RX) section above.
