4
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
This device is intended for indoor use only.
Take care to avoid spilling resin on or in the printer. Wipe up any spills immediately.
If resin or moisture does get in the printer, immediately unplug it from the AC
power outlet and allow it to fully dry before reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet
hands.
Do not install this device on an unstable surface where it could fall and cause either
personal injury or damage to the device and/or other equipment.
Do not expose this device to excessive vibration. Do not subject the product to
extreme force, shock, or fluctuations in temperature or humidity.
Ensure that the cooling fan is not blocked and that it operates as intended.
This device ventilates excessive heat through the slots and openings in the case. Do
not block or cover these openings. Ensure that the device is in an open area where
it can get sufficient airflow to keep from overheating.
Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
This device uses a grounded power cord and requires a ground connection for safe
operation. Ensure that the power source has a proper ground connection. Do not
modify the plug or use a "cheater" plug to bypass the ground connection.
Disconnect the unit from the power source when replacing the fuse. Replace the
fuse only with the same type.
Unplug this device from the power source when not in use.
