9
POWER LED on the front panel will illuminate green, indicating that the matrix is in
standby mode.
10.
(Optional) Determine the maximum resolution and audio capabilities of your least
capable display (the one with the lowest resolution and fewest audio channels),
then set the DIP switches on the rear panel to the appropriate positions for the
video and audio capabilities. See the
EDID MANAGEMENT section for details on
how to set the DIP switches.
11.
Plug in and power on all connected equipment. Start video playback on each source
device and verify that the video can be seen on each display. Use the IR remote
control to verify that you can switch each output to view the video from each input.
Refer to the
OPERATION section for operating instructions.
Congratulations, your new matrix is now installed and ready for normal operation.
CONNECTION STATUS
Press any of the four OUTPUTS buttons on the front panel. The LED for the connected
INPUT will briefly illuminate.
CONFIGURING FOR DIRECT TCP/IP CONTROL
If you connected the matrix to an Ethernet switch or router, there is nothing special that
needs to be done for TCP/IP control. Refer to either the
TCP/IP Software Control or TCP/IP
GUI Control portions of the OPERATION section below for connection and operation
details.
However, if you connected the matrix directly to the Ethernet jack on your PC, you will
need to configure it to communicate with the matrix. Perform the following steps to
change the network connection settings:
1.
Open Control Panel.
2.
Click the Network and Internet option.
3.
Click the View network status and tasks link.
