9
source device. Alternatively, if you want to control the remote display from the
source end, plug the include IR transmitter into the IR OUT jack on the receiver, then
position the IR emitter where it can transmit IR signals to the IR "eye" on the display.
10.
Plug the DC barrel connector on the included AC power adapter into the DC IN jack
on either the transmitter or the receiver, the plug the adapter into a nearby AC
power outlet. Note that the unit that is not connected to the AC power adapter will
receive its power from the other unit over the Cat6 Ethernet cable.
11.
Plug in and power on all connected equipment. Start video playback on your source
device, then verify that you can see the video on the remote display. If you are
using the IR extension feature, verify that you can control the intended device from
the other end. If you connected computers or other network devices to the
ETHERNET ports, verify that you have network access to the connected device.
FIRMWARE UPDATE
Perform the following steps to update the firmware for both the transmitter and receiver.
1.
Plug the included 3-pin to DB9 RS232 Cable into the 3-pin RS232 connector on the
receiver or transmitter, then plug the other end into the RS232 serial connector on
your PC.
2.
If you will be updating the Valens IC program, slide the RS232 Mode Switch to the
UPDATE A position. If you will be update the Compression IC program, slide the
RS232 Mode Switch to the UPDATE B position instead.
3.
Locate the update batch (.bat) file on your computer and double-click it to run it.
