6
ASSEMBLY
Perform the following steps to assemble the lectern.
1.
Place the Lectern Column upside down on the floor.
2.
Using a #2 Phillips screwdriver, remove the 6 screws from the bottom of the
Lectern Column.
3.
Place the Lectern Base on the bottom of the Lectern Column with the screw
holes aligned.
4.
Using the screws removed in step 2 and a #2 Phillips screwdriver, attach the
Lectern Base to the Lectern Column.
5.
Carefully turn the Column and Base assembly over so that it is resting on the
Base.
6.
Using a #2 Phillips screwdriver, remove the 6 screws from the top of the Lectern
Column.
7.
Place the Lectern Apron on the top of the Lectern Column with the screw holes
aligned.
8.
Using the screws removed in step 6 and a #2 Phillips screwdriver, attach the
Lectern Apron to the Lectern Column.
9.
Place the Lectern Top upside down.
10.
Using a #2 Phillips screwdriver, remove the 4 screws from the bottom of the
Lectern Top.
11.
(Optional) If you wish to add an additional condenser microphone to the system,
plug a condenser microphone into the 3-pin Male 91 MC3M Amphenol connector
on the top of the Lectern Column, then feed the cable through one of the
vertical slots in the Lectern Apron.
12.
(Optional) If you wish to add another lamp or other device that requires power,
plug the device's AC plug into the NEMA 1-15 power outlet on the top of the
Lectern Column, then feed the cable through one of the vertical slots in the
Lectern Apron.
13.
While holding the Lectern Top on the Lectern Apron, attach the 9-pin connector
from the top to the 9-pin connector on the top of the Lectern Column.
14.
Position the Lectern Top on the Lectern Apron with the screw holes aligned.
